The world's #1 resource for everything Subaru Tecnica International, with a core focus on supporting every individual in a positive environment, regardless of experience and technical ability.
By adding that 1 foot of line you are creating a damper area for the fuel system. Not the best fix but it should work. Its like the rally turbocharger pipes with the Air reservoir near the throttle. Fuji correct me if I'm not mistaken on this. To much purple haze to think straight...
Ok, I'm going to apply most of the stuff that I have read here to my genesis. Lets see if the general knowledge applies over platforms. I have intake and exhaust vvt but never touch them for the sheer fact that I was unsure on how to go at them. Freakishly small turbo wont help out but lets...
The turbo was going to be ceramic coated with a turbo blanket also placed over it. Under hood temps wouldn't be any crazier in comparison to a gt35. Now that the controller is coming out, I might even pick this up again from the bottom up but might try it in an 2.5Rs box instead of an newer...
Jordan @Defined can hook you up. Also, I have never used a divorced wastegate dp. Not in any subaru that I had, not even possible in my genesis. The design is efficient at most but you wont get mad gains from running one. Back in the day, the term was used more as a marketing gimmick than...
I'm looking to buy a used meth kit. I want it to be boost referenced and progresive. I'm located at 00659. Send pm if you have one for sale or know of some one that is selling.
This is for my genesis... pos car is knocking with 91oct...
Thanks for looking.
John.
In some cases the car will stall with a CAI due to the lean mixture and turbulence created in the intake track. This needs to be tuned out so that you don't experience said problems. A BOV in conjunction with a CAI will make this problem stand out. You can drive around with it, but I...
I never tried to advance timing on boost, yet if I read correct it does good to power to advance timing on that range? Idk. Ill guess Ill need to buy an Sti again and put this to the test ;)
When the LC-1 is burning out it will lose its settings upon power up. It will start getting al screwed up until at one point it wont read no more. The light will go on and the sensor heater will work but you wont get any readings from it. Mine started doing that before it died. I bought an...
Ok. The last time that I did a fuel pump install "2 years ago" It was very straight forward. It was with a Walbro 255 but the same thing applies to the dw200. Did all the clamps fit in correctly? You could have a fuel leak in there with the new pump in place. Pics would greatly help the...
I wax my car with Zymol. When I clay, I use Meguiers clay. I have tried all sorts of waxes from Turtle, Meguiers and some other crap. I'm happy with the shine that Zymol gives to the paint and it last about 1 to 2 months on the car in Puerto Rico weather.
PS. She looks clean!
A water cooled turbo CHRA runs at lower temps than those with out. Thanks to this the oil stays way bellow the cooking threshold and you do not need to give it time to cool down. Have in mind that the water will keep circulating in the turbo while the car is turned off due to temperature...
You don't need to hoist the engine. Just undo the passenger side engine mount and lift a tad bit from that side. Then wiggle it up and it should fit. That's how I did mine.
Its all in the tune. Do you have your mod plan? Parts List & costs? Its not just a matter of choosing the turbo, but the parts that will allow it to work safely.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.