The world's #1 resource for everything Subaru Tecnica International, with a core focus on supporting every individual in a positive environment, regardless of experience and technical ability.
I did however use my old clutchkit from the wrx when the swap was done and it seemed to line up fine and had no issue besides the fluwheel being warped. Im hoping the ACT will be the same
Sent from my iPhone using Tapatalk
Its a standard GT transmission from 07 the clutchkit I purchased is an act stage three with the street light. My tuner said the 07 should be compatible with the wrx but I just want to make sure before I throw it in the car.
Sent from my iPhone using Tapatalk
I have a Legacy trans in my 08 wrx and I need a clutch. Could I run a wrx clutch or would I need to buy a legacy clutch?
Sent from my iPhone using Tapatalk
I put the hose for the smoke tester in the line for the brake booster and if I dont tape up the intake tube all the pressure leaks out. I let it idle for abt 10 mins after the reset to let it relearn.
Sent from my iPhone using Tapatalk
So it seems like I found the issue. I did a smoke test because that was all I could do at the time and didnt find anything. But I had to take off my intake and tape it up so that pressure wouldent leak out of the filter. In the process of putting it back together I found that one of my clamps...
I would assume its the stock ecbs although im not even sure where its located. I think its the thing next to the alternator though. I just went through and centered up that line and tightened it. I reset the ecu again in hopes it would help and not much changed. Ill try the boost leak test...
Engine(built at 102k):
Fully built shortblock 99.75 bore
STi nitrided crankshaft
Manley 99.75 platinum pistons
Manley H-beam rods
King Race rod bearings
Factory main bearings
STi oil pump
Tigwerks oil pickup
Fully ported heads
EGR & SAI delete
TGV delete
Clutchmasters FX350 clutch
Aluminum...
Peak boost is set at 19 psi in the weeks before I dropped off the car to get the trans replaced I noticed that it was only able to reach abt 16 or so on a good day. When I got the car it would sometimes even reach 20. When I got the car back it felt much slower and it would stutter and lean out...
Ill do a boost leak test tomorrow. I dont have a wideband. What should I look for under roughness? My injectors arent really close to maxed out but my fuel pump reads 100 percent duty cycle at points, is this normal? Ill take a video tomorrow and post it to this thread. Thanks
Sent from my...
I just reflashed and it didnt really seem to do much except idle a little rougher. What else should I check? Plugs maybe?
Sent from my iPhone using Tapatalk
So I got the harness in and its no longer throwing the code but my issue persists. What should the MAP sensor read at idle? Mine is around 4.7 psi I feel like that is really low.
Thanks
Sent from my iPhone using Tapatalk
Ok is that the same thing as reflashing? I tried that a couole weeks ago and it actually seemed to help the car at least at idle. Maybe this rear O2 has more to do with it than I thought.
Thanks
Sent from my iPhone using Tapatalk
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.