Idiots guide to fitting wheel nuts - McGard Black Edition's

salsa-king

Member
For a while I've wanted to swap my OE chrome wheel nuts to something better as they are starting to look tired. After seeing the write ups about alloy nuts sheering off I knew I wanted quality. The only ones to go for are McGard - obviously IMO.


When I went to the International Autosports show at the NEC (UK) earlier this year I came across the McGard stand, where I soon asked about their wheel nuts for my Subaru STi 330s which I wanted in Black.


A deal was hammered out for a FULL set (inc wheel locking nut) of the Black Edition that were subaru fitment.


Today I've had chance to fit them.


So here you go with an idiots guide to swapping your OE ones for the new Black Edition's.


20160410_110910_zpsl0ioqofn.jpg




Start with removing the OE locking nut

20160410_111421_zpsuzljxysm.jpg




to be on the safe side use some lube/oil so you can get them off either next time round
Set1_smile.gif

20160410_111453_zpsxgmycagl.jpg




1st one fitted.
20160410_111723_zpscny4vuse.jpg




2nd one will be the opposite side, then the 3rd opposite to that one.
20160410_112100_zpsp6g6lulh.jpg




4th & 5th again done as opposing sides like doing the ones previous
20160410_112424_zpscyzsneso.jpg




Don't forget to Torque them up to just a shade under 100Nm
FB_IMG_1460286631204_zpsywwflcl4.jpg






I just need to full detail my car now ready for the show season ;)
 
Top