Latency Issues

zkemp82

New member
I'm having some issues getting my latency set correctly. I'm using the TrimError Tool, and I cannot get the line to get anywhere near flat. The average slope goes upward, but when I make the adjustments, my car starts running like crap, knock goes up to -11.8 and DAM drops to 0, bit AFRs are good. It seems that no matter what I do to the latency values, it's never good enough to move on. I thought I had it previously, but found out I had a leaking vacuum cap. Fixed that, and everything just seems to be all over the place. If anyone can help, I can send the TrimError Tool files, but I can not attach them here. Just need some help because this is getting irritating.

06 WRX
TGV Deletes, DW 1000's, VF 48, Stock intake w/ Cobb After MAF and Mishi Inlet, 2010 STI TMIC, 3" TBE Catless, 2" UP w/ EWG setup (currently blocked off), Cobb EBCS, Killer B Oil Pan/pickup/baffle, stock header, Cobb Flex Fuel Kit w/ FP sensor, MLS Parallel fuel setup w/ Rails, Aeromotive FPR & AEM 340 fuel pump
 
Top