Thanks for the addition.

ke4640

New member
Hey guys.

My names Kirill, been around Subaru's for quite some time now. Currently living in Clearwater, FL due to my assignment to duty station down here. I run the Annual Tail of the Dragon Boxer Takover at Deal's Gap. NC. Be sure to check out the awesome Subbie event at annualboxertakeover.com

Previously had a 2001 2.5RS which I sold about 6 year's ago.
2s1rbqx.jpg


2011 I bought my 2005 STi, had ringland failure shortly after. So we did a little work. Ended up with a full forged motor, and a facelift. It started to get a little older than I wanted a car to be. So I sold it to buy my 2011 Chevy Silverado and in search of a project RS again.

Original STi
ea1ets.jpg


BUILT AND CONVERTED TO THIS.

4kjtj5.jpg


and finally

e7dq9k.jpg
 

Alin

Diehard Car Enthusiast!
Welcome to IGOTASTI!!!
[MENTION=4577]TK-421[/MENTION]
 
Nice, what's done under the hood ;) any protune/dyno runs?
 

ke4640

New member
The long block was completely built by DailyDrivenPower and some help from me.

Short Block:
Bored to 100mm, Hot tanked, Cleaned, and Re-Coated by Amtex in Ybor City, FL
JE FSR Piston's
Manley Turbo Tuff Rods
King Reg and Oversized Bearings
New Oil Cooler
New Gates Timing and Belt Kit
New Oil Pump
All new OEM Gasket kit



Heads:
DailyDrivenPower Super Sexy 3 Angle Valve Job again machined by Amtex in Ybor City, FL
as well as Hot Tanked, Cleaned and Re-Coated
New GSC OEM Spec Valves and Springs
New OEM valve hardware
New Bucket's due to the valve job
New Gaskets and Hardware
ARP Head Studs

Full Exhaust consisting of DC Headers and Up-pipe I believe. (don't quote me, previous owner installed it). Invidia downpipe, and HKS Hi-Power.
AEM Short Ram (also installed by previous owner) < dumb, I know.

We did an airboy and where getting around 315whp/330wtq on the stock VF39, stock injectors on 93, MAF.

Tune was done by DDP
 
Top