skritz12
New member
For Sale
2012 STI 22,100 miles on car 2,200 on build.
Build:
Brand new block
Cosworth Pistons (8.2-1 compression)
Manely H beam rods
ACL race bearings
New heat treated and balanced crank
ARP head studs
ported and polished heads
Brian Crower stage 1 valve springs with titanium retainers
Grimmspeed TGV delete
Grimmspeed Phenolic 8mm spacers.
Garrett GTX 3076 turbo
Front mount Intercooler.
Grimmspeed EBCS 3 port
Perrin 3in turbo inlet.
Perrin AOS
ID 1000cc injectors
DW65 Fuel pump
Grimmspeed lightweight crank pully
Gates racing timing belt
Clutch master stage 2 clutch and Aluminum flywheel
Rotta Rims with brand new Falken tires 2500 miles on the tires
Invidia Downpipe and N1exhaust
Swift lowering springs
Cobb AP V2
Tuned by The Boost Creep ltd on E85 and 91 Octane
Car made 410 awhp on E85 on 20 psi prior to TGV and head work being done, should be closer to 425WHP on same boost. I have a lot of stock parts still including rims, and exhaust. Car is located in Cheyenne, WY. The interior is perfect condition and only rock chips on the exterior. Car has been very well taken care of. Asking $34,000, I also have ID 1300cc injectors, 4 bar MAP sensor and intake air temp sensor and MAF block off plate that have not been installed yet.
Check out the video by Force Fed productions
2012 STI 22,100 miles on car 2,200 on build.
Build:
Brand new block
Cosworth Pistons (8.2-1 compression)
Manely H beam rods
ACL race bearings
New heat treated and balanced crank
ARP head studs
ported and polished heads
Brian Crower stage 1 valve springs with titanium retainers
Grimmspeed TGV delete
Grimmspeed Phenolic 8mm spacers.
Garrett GTX 3076 turbo
Front mount Intercooler.
Grimmspeed EBCS 3 port
Perrin 3in turbo inlet.
Perrin AOS
ID 1000cc injectors
DW65 Fuel pump
Grimmspeed lightweight crank pully
Gates racing timing belt
Clutch master stage 2 clutch and Aluminum flywheel
Rotta Rims with brand new Falken tires 2500 miles on the tires
Invidia Downpipe and N1exhaust
Swift lowering springs
Cobb AP V2
Tuned by The Boost Creep ltd on E85 and 91 Octane
Car made 410 awhp on E85 on 20 psi prior to TGV and head work being done, should be closer to 425WHP on same boost. I have a lot of stock parts still including rims, and exhaust. Car is located in Cheyenne, WY. The interior is perfect condition and only rock chips on the exterior. Car has been very well taken care of. Asking $34,000, I also have ID 1300cc injectors, 4 bar MAP sensor and intake air temp sensor and MAF block off plate that have not been installed yet.
Check out the video by Force Fed productions
