SirMyztiq
Member
I think I should make this a thread since my old one got kind of luck and this is a whole new topic. Recently my brother and I removed the intake manifold in order to replace a leaky intake manifold gasket. While in the process, we removed what I believe are the TGV motors. There was one on each side and when removed they left behind little gear looking things and the motors themselves had teeth. We removed them because they were getting in the way as we tried to remove the manifold. We had no idea what they were at the time. After we put them back together, there was a "intake manifold runner stuck open code" which went away after a couple of resets and restarts of the engine. It came back today! I think we might of put them in wrong but I can't find the proper way to install them. I hope its nothing too hard to fix and I do not want to take out the manifold again. How do we fix this!?
By the way, it is bank 2.
By the way, it is bank 2.